The Utility More progress reveals new trouble spots

More fairing. This time, it has been a matter of fairing the overhanging edges of the side planking down to meet the chines.

For the most part, I have been doing this with a power sander and with a sanding block, along with occasional help from a hand plane. I also bought a “multi-tool” oscillating saw to trim the planking up forward, where accurate fitting along the mid-width of the chine is required.

A large portion of this work is done. However, as I look down the length of the chine to check for “fairness” of line, I’m seeing some new trouble spots. It appears I’ve got a couple of low spots in the chine, particularly on the port side... the dreaded “humps and hollows” mentioned in Boatbuilding With Plywood

Once I get some remaining areas fully sanded, I’ll be able to assess the problem more accurately. However, it’s already looking like I will have to add some more strips of wood to fill these areas. That means more fairing. (Yaaay!) Oh well, it will be for the best if so.



The dreaded "humps and hollows" are plainly visible along the port chine.

To a lesser degree, the same issues are visible along the starboard chine.

Fairing progress at the transom. I still need to sand away those Raptor staples.

Still need to encapsulate the limbers before planking the bottom of the boat.

Also need to encapsulate the sole supports before planking the bottom.

Test-run of the transition joint. Ill probably move this forward an inch or so.

Test-run of the transition joint. Ill probably move this forward an inch or so.

Here is the cut I made along the forward curve of the chine, using an oscillating "multi-tool" saw.
So far, Ive been very happy with the Porter Cable multi-tool I bought. It is very easy to use.

Related Posts by Categories

0 komentar:

Posting Komentar




Blog Archive

Diberdayakan oleh Blogger.