The Utility part 1 Getting started

The Glen-L Utility is a simple but classic 1950s utility / fishing boat. It is 11 LOA, with a 5 beam, wood foredeck, open cockpit, and simple thwart / bench seats. Specs say it can carry up to 3 average passengers. Most of the photos Ive seen of them show basic tiller outboard steering. I got my plans around early April of 2012 & got started immediately.

Having learned my lesson about asymmetry in the construction of the frames, I approached the Utilitys frames very differently. First, I drew out frames 1 and 2, as well as the keel  backing, full-size on a sheet of 1/4" marine-grade Douglas Fir plywood.


Frames & keel backing traced out on the plywood.
Then, I traced all the frame members from the plans directly onto some 3/4" mahogany, and cut them out with much more care and attention to detail than I did with the Squirt. 

I learned an interesting thing about mahogany. Apparently, it is rather light sensitive. Driving home from the lumber yard, a small portion of the board was sticking out my back window. After about 2 hours in the sun, that part had turned considerably darker, as seen on the keel in the photo below.

Keel and frame members laid out on the plywood.
In order to maintain the best possible shape and alignment of my frames, I then epoxied the frame members directly onto the plywood. I later used the scrap from the cut-out portions of the plywood to make my remaining frame gussets.

I fastened the gussets onto the frames using Glen-L Poxy Shield epoxy, (thickened with #2 silica filler), and 1-1/4" bronze screws. The frames & interior surfaces of the transom were encapsulated with 3 layers of Poxy Shield. After each layer dried, I scrubbed & washed off the amine blush using dish detergent, warm water & a Scotch Brite pad. I also sanded lightly between the layers with 220 grit sandpaper.

Gluing the forward frame members onto the plywood.
The frame notches in the plans are 1" deep (other than the keel notch, which is 1-1/4"). Most stock sold as 1" these days is actually 3/4". If I were doing this again, I would probably change the notches to 3/4" in order to use some less expensive & more available boards.

Another thing I did differently than with the Squirt was to take construction of my building form much more seriously. I made it from 2x8s and 2x6s, with well-reinforced cross braces made from 2x4s left over from the Squirt form. I took a lot of care to make sure the surfaces were level, clamping them into position before fastening with 3" wood screws. Trying to build something with level surfaces on a sloped floor was a little tricky. The key is to mark the positions of the legs on the floor once youve gotten the parts level. That is, unless youre going to bolt the form to the concrete floor. Thats the preferred method, but several builders dont do that. I didnt.


Frames, transom and keel on the building form.

Related Posts by Categories

0 komentar:

Posting Komentar




Blog Archive

Diberdayakan oleh Blogger.