Here are the two bottom panels taped and cut to shape. I feel as if I am in the groove now and can get the side panels out a little quicker now.
I did experiment with a number of release films for the fiberglass epoxy tape joints.
1. 6 mm plastic - was hard to get flat and fair. wrinkles developed easily
2. packing tape - harder to apply, but left a relatively smooth controllable surface.
3. wax paper - best looking joint, but waxy residue must be cleaned. I was warned by a more experienced builder that the wax could separate out of the paper, leaving a ghastly mess to clean up. I did experience a little of this in the top joint, when I tried to remove the paper prior to full cure.
Bottom line - will stick with the 6 mm plastic. a little extra filling and sanding is part of the project.
0 komentar:
Posting Komentar