Rudder is now under way. Took a while to draw the layout lines from the plans and then scribe a reasonable curve. Bought reading glasses to read the fine print on the plans.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEjhavm5JwJ9_YBoh6ivnbiVhkxKqxInEbvKaiZrjDgEqsqr3CaAWzSU28rFbT19cYITsYR5JsKleobVHaS-Fk3nVVWVS-Y2vMfRhyFL0tvf8Wy9tRvLVI-Qz7gqyBxDyXrCz2uy_dKRZec/s320/20131231_173236.jpg)
rudder is penciled in and 3/8 ply doubled up. ready for glue.
The dark spot is residual baking soda from a spill earlier in the construction process. Will not be finished clear anyways. High gloss smooth.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEinIrdNOZcf1pPMUUVylFos5y5TtgAkYs0A_Nj_sWR-T5mtPcuNP05VgQzyvTb8_N6uKgHsEopWBl8mAnEMLyoApru78uOtRAqoEGaIi0bd8N-1HCeIHy7GZku14DpdfES91n3voi8Tymw/s320/20131231_173159.jpg)
Mock up of water bottle and gym weights, glue tomorrow.
ADDENDUM -
The rudder blank was not lying flat enough for my liking, so nailed down the perimeter while the glue sets off. Stay tuned...
1-4-14
The rudder came out fine. I then moved on to the cheeks for the stock. The plans show a trapezoid with only one right angle not coinciding with any of the lines, and a diagonal to show the angles on the trapezoid. After trying to mark this onto the plywood for an hour and a half, I gave up and went to bed. Today, got up and pulled out the Masonite I had used for the centerboard trunk and made a pattern. As lines are easily removed, this took far less time, and cut so well that just a little fairing up with sandpaper has given me a nice pattern to work from. Also discovered a plank of 5.5" mahogany in the garage for the filler blocks.
rudder stock blank sitting on top of the blade stock. easy to see how these pieces work together. |
![]() |
ready for shaping. will trim the little spot in the upper right corner after rudder stock is built. this area controls the pitch of the blade. 7/8 needs to be forward of the stock for balance. |
![]() |
rudder cheeks, next is the filler block. and doublers. |
![]() |
Whole assembly mock up. |
![]() |
Pivot tested. Time to shape blades, and order hardware. |
0 komentar:
Posting Komentar